PEDAL IS FULLY FUNCTIONAL

Features

9 volt DC powered

Now you can use those nice power supplies that are available (like the Voodoo Labs Pedal power2) or an optional wall wart. That 9 volts DC is converted to 18 volts DC internally to retain headroom and ability to use the original bulb that is so very important in getting the right "throb" or "wobble" in the sweep. The mojovibe will not run on batteries and the US 120V wall wart is optional for $15.

Internally switched FET buffer pre-amp

Switched with a miniature DIP switch, you can choose the warm vintage input configuration or a modern fet buffered input for a brighter sound. This differs in that most vibe makers switch a simple resistor in and out for the two different styles, but it still chokes off the response of your guitar. With the fet buffer this will not happen. The only time the buffer (when selected) is present is when the effect is engaged. Not to be confused with a buffered bypass. It is still true bypass.

Speed Controller Input

Just about any passive type volume pedal or expression pedal will work with the Mojo Vibe. We sell the Roland EV-5 which is great as a controller. Of course some better than others, due to the value of the pot in the pedal. The ideal value would be a 100K reverse log taper. But I have found that many other values will work satisfactorily. To conserve space the Mojo Vibe uses a ¼" stereo tip, ring, sleeve switching jack for the controller input. You can use it as is with expression pedals where the cord is already connected to the pedal such as Roland, Ensoniq and other keyboard expression pedals. To use a passive volume pedal you will need a special cord that consists of a ¼" stereo plug on one end and splits into two mono ¼" plugs. These are the same cables used in the channel inserts on mixing consoles and are readily available at most music stores.

Chorus / Vibrato Switch

Ok, so it’s not really a chorus as we know them, but we’ll stay with the original terminology. This uses a short bat (so it’s hard to break off) miniature toggle switch to decide the output. Either the original "chorus" / Uni-Vibe sound or a wild vibrato can be chosen with this switch.

Volume Control

Adjust the output to match the input level.

Intensity Control

Adjust the depth or "intensity" of the effect, also effects the bias of the sweep to some degree.

Speed Control

Adjusts the speed of the sweep. From a slow rolling phase to a bubbling, watery, pulsing throb.

True Bypass with LED that pulses in time with the speed setting. 

Aluminum Case

Chosen over steel for superior shielding properties and lighter weight.